ACRYLOSAND™ can be used on most any Interior or Exterior Substrate including: wood, primed metal, galvanized, primed synthetic or aluminum siding, tin, copper, asbestos, asphalt, urethane, polyester, styrofoam, foam, fiberglass, clay, adobe, brick, stucco, slate, cement block, poured concrete, slab and various other substrates.
The ACRYLOCOAT™ brand Product Line is excellent to decorate and enhance the exterior walls and facades of buildings, homes, and facilities including: residential, commercial and industrial applications.

ACRYLOSAND™ SURFACE PREPARATION:
If ACRYLOSAND™ is used in the 15 Year Warranted ACRYLOCOAT™ Decorative Finish Protective Coating System, please inquire for a detailed application procedure sheet and strictly follow the application method. If Applicable, trenching is necessary to form a complete seal; trench 4 to 6 inches around the perimeter of the structure. For proper adhesion to an existing substrate, it is essential that the surface be pressure washed at a minimum of 1500 P.S.I., using a water and chlorine solution, removing any loose, flaking or peeling paint along with any dirt, oil, grease, residues and especially mold, mildew and algae. Wire brush if necessary. Apply only to a sound, well prepared wall surface. Rusted metal must be primed. Inquire about METAL-PRIME RED-OX™ Rust Treatment Process.
Patch any holes, cracks, seams, imperfections, etc., with ACRYLOPATCH™ Waterproofing Caulk & Sealant. It is recommended to use ACRYLOPRIME™ before application of ACRYLOSAND™, and a coat of ACRYLOSEAL™ or ACRYLOSATIN™ Finish Coat over the ACRYLOSAND™. Wait 12 hours between coats of any of the ACRYLOCOAT™ Product Line.

ACRYLOSAND™ APPLICATION PROCEDURE:
No thinning is required, use product as is from the container. Hand stir or use a heavy duty drill motor with a paddle type blade to mix if necessary.

Do not apply when temperatures are below 45 degrees Fahrenheit or when humidity is very high. ACRYLOSAND™ can be sprayed with equipment as basic as a hopper gun and can produce unlimited textures simply by adjusting the air pressure and/or the size of the spray tip. This method also helps provide different knock down finishes.
ACRYLOSAND™ can be applied using a heavy nap roller to produce a smooth sand finish as well as many other aesthetic finishes. Clean all tools and equipment immediately after use with warm soapy water.