SUPER BOND™

SUPER BOND™ is a fast drying clear acrylic bonding adhesive primer and surface conditioner with exceptional adhesion to most any surface. This high performance multi-use latex bonding primer dries to a hard finish and can be top coated with most any paint or coating.
SUPER BOND™ has superior adhesion for those hard to paint surfaces such as PVC pipe, most plastics, fiberglass, glass, aluminum, rubber roofs and galvanized metal. Works well for use as a chalk sealer and as a primer on previously painted surfaces.

SUPER BOND™ is a unique interior and exterior adhesive bonding primer for use on most any surface including: PVC pipe, many plastic substrates, fiberglass, glass, aluminum, galvanized and anodized metal. Excellent for use as a chalk sealer and bonding coat on previously coated masonry, stucco, wood and metal surfaces. SUPER BOND™ Can be used as a primer on certain types of roof surfaces including: rubber roofs, EPDM (ethylene propylene diene monomer) and PVC roofs.
SUPER BOND™ is ideal for use on Residential, Commercial, Industrial and most other applications.

Note: Do not use SUPER BOND™ on any type of unprimed ferrous metal, bare wood or new and uncoated masonry, stucco or plaster or any other uncoated cementitious surfaces.

SURFACE PREPARATION:
For proper adhesion it is essential that the surface is prepared properly. Clean exterior surfaces to remove any previous peeling coatings, dirt, grease and other foreign materials, especially mold, mildew and algae by thoroughly pressure washing with a water and chlorine solution using at least 1500 P.S.I. Rinse thoroughly after cleaning and allow the surface to dry completely. Remove loose paint and powdery substances. Patch any holes, cracks, seams, imperfections, etc., with PERMAPATCH™, Waterproofing Caulk & Sealant. Clean interior surfaces to wash off all dirt, grease, soap and oil build-up with a powdered household cleaner and water, then rinse or wipe off thoroughly with water using a damp cloth and allow the surface to dry thoroughly.

APPLICATION PROCEDURE:
Mix thoroughly before use. Do not thin, use product as is from container. May be applied by brush, roller or spray. Do not apply within 2 hours of expected rain or heavy dew. Do not apply when air or surface temperature is below 50 degrees and above 110 degrees Fahrenheit. Chalk Sealing: To seal chalk, SUPER BOND™ should be rolled and worked into the surface. Note: Do not use SUPER BOND™ on any type of unprimed ferrous metal, bare wood or new and uncoated masonry, stucco or plaster or any other uncoated cementitious surfaces. Do not let spatter cure on glass as it will etch the surface.

CLEAN UP:
Clean all spills and tools immediately after use while coating is wet with warm soapy water.