PRO-SEAL LINK™ has many practical uses: Wood Sealer, Masonry Sealer and Drywall Sealer before a finish coat is applied. Vapor Barrier and Moisture Sealer on wood and masonry. Bonding Coat that insures a lasting bond between substrate and paint or coating. Stucco Bonder that adheres the stucco to concrete or block surfaces. Bonder for concrete pavers. Gloss Additive that provides extra gloss when added to latex paints. Flow Additive that will increase the flow and leveling in latex paints for a smoother finish. Cement and Masonry Anti-Fracture and Flex-Additive that will give most any cementitious mixtures flexibility to resist and possibly prevent hairline cracks in cement, concrete, stucco, plaster, etc. Cementitious repairs, concrete voids (honeycomb), spatterdash coats, plaster adhesion. Roof Slurry Mix Additive to help in adhesion to the substrate and also adds flexibility to the cementitious mixture to reduce cracking.

SURFACE PREPARATION:
For best performance prepare the surface properly. Pressure wash the surface if possible with a minimum of 1500 P.S.I., using a water and chlorine solution. The surface must be clean, and free of all surface contaminants such as wax, grease, oil, dirt, loose or flaking material, acid substance, soap deposit and especially mold, mildew and algae. Glossy painted surfaces must be de-glossed. Apply only to a totally dry surface free of all moisture.

APPLICATION PROCEDURE:
Stir contents thoroughly. Apply with brush, roller or spray. Apply at temperatures above 45 degrees Fahrenheit. Apply uniformly and do not leave any puddles. For extra penetration on porous surfaces you may thin with a maximum of 1 pint of water per gallon of PRO-SEAL LINK™.

ADDITIVE RATIOS (RECOMMENDED):
Latex Paint Additive for Flow or Gloss:
1 pint PRO-SEAL LINK™ per gallon of paint.
Cement or Masonry Anti-Fracture and Flex Additive:
Aat least 1 quart of PRO-SEAL LINK™ per 50 pounds of cementitious material.
Roof Slurry Mix Additive:
5 gallons PRO-SEAL LINK™ per 50 Gallon Batch. (Slurry Mix Formula Available)
Cemtitious Repair 3:1 Sand-Cement - PRO-SEAL LINK™
Thin Coat Repair 2:1 PRO-SEAL LINK™ - Water

NOTES:
1. Experiment with different amounts of PRO-SEAL LINK™ to achieve your desired effect. 2. Adding PRO-SEAL LINK™ to paint will decrease hide and possibly reduce mildew resistance.

STUCCO or PAVER BONDER:
Apply a liberal coat of PRO-SEAL LINK™ to the substrate. Let dry approximately 1 to 2 hours before applying the stucco or cement mixture.

CLEAN UP:
Clean up all spills, tools and overspray immediately while the coating is still wet with warm soapy water.